SoundDomain.com: Dual Amp Wiring

You are not logged in. [Log In] SoundDomain » Forums » Car Audio General » Electrical Explanations » Dual Amp Wiring

Page 1 of 1

Topic Options

#1701817 - 09/03/09 03:09 PM

Dual Amp Wiring

hope2b7ft
SD Ralph Wiggum

Registered: 04/20/07
Posts: 67
Loc: Iowa

Offline

I've never ran two amps before, but I am about to for my new vehicle. The rms wattage for both amps combined will be 1150 (1300 when I buy some new components). What size of wiring is recommended for a dual amp install? Amps are eD NINe.1, and powerbass ASA-300.2. Thanks in advance.

Top

#1701822 - 09/03/09 03:20 PM

Re: Dual Amp Wiring [Re: hope2b7ft]

Comic Book Guy
Worst. Episode. Ever.
SD First guy voted off Survivor

Registered: 08/11/09
Posts: 654

Offline

i would run a 1/0 main power that feeds a distribution block and splits to 4awg. then your amps will feed 4awg to a second distribution block which will ground to the chassis with 1/0.

_________________________
Daily Ground Pounder

http://www.powerbassusa.com

- meh, if you close your eyes you can't tell the difference. /quote

Top

#1701827 - 09/03/09 03:34 PM

Re: Dual Amp Wiring [Re: Comic Book Guy]

hope2b7ft
SD Ralph Wiggum

Registered: 04/20/07
Posts: 67
Loc: Iowa

Offline

Thanks for the quick response. Just to make sure I understood this correct, after I send the power wire thru the first distro block, the second distro block should ground with 1/0 gauge?

Top

#1702018 - 09/04/09 08:22 AM

Re: Dual Amp Wiring [Re: hope2b7ft]

Comic Book Guy
Worst. Episode. Ever.
SD First guy voted off Survivor

Registered: 08/11/09
Posts: 654

Offline

yes.

_________________________
Daily Ground Pounder

http://www.powerbassusa.com

- meh, if you close your eyes you can't tell the difference. /quote

Top

Page 1 of 1

Previous Topic View All Topics

Index Next Topic

Moderator: imtfox, keep_hope_alive, xTHANATOPSISx, TtownCLS

Hop to: