Channel 1 Zone Select
After entering Programming Mode, press within five
seconnds to toggle between hood, trunk, and hood and trunk.
The remote will bep once and show hood icon for hood, beep
twice and show trunk icon for trunk, and will beepthree time
and show both icons for hood and trunk. The default is the tunk.


what does this mean?

The zone number is the number of LED flashes used by the
system to identify that input. The standard input assignments
are listed below, along with spaces to write in any optional
sensors or switches you have had installed.
interpreting zone diagnostics
Warn Away responses are not reported by arming or disarming
diagnostics. If you receive a Bypass notification when arming or
a Tamper Alert notification when disarming, look at the LED.
Active or triggered zones will be indicated by a pattern of blinks
by the LED.
Example
If Zone 3 was active or triggered, the LED will blink three times
with a two-second pause. Then it will blink three times again,
and repeat until the ignition is turned on.
➜
Zone - Number Dealer-Installed
of LED Flashes Description Options
1 Instant trigger - often used
for hood/trunk pinswitches
2 Instant trigger - a heavier impact
detected by the shock sensor
3 Door switch trigger
4 Instant trigger - for optional sensors
5 Ignition trigger

what does this mean

what about the other $hit on my alarm?>

Channel 1 Zone Select
After entering Programming Mode, press within five
seconnds to toggle between hood, trunk, and hood and trunk.
The remote will bep once and show hood icon for hood, beep
twice and show trunk icon for trunk, and will beepthree time
and show both icons for hood and trunk. The default is the tunk.

thiS? what does this mean?

Also is there a way I can get my remote to reach up to a mile?