How many amps are being used? What amps are being used? There is a few variations you could end up with. But it all depends on the subs and amp(s). Do you have any more info at all?
you either running 6 or 3 amps depending on the wattage and i can tell you which amps i would pick for the 3 amplifiers i would either run parallel or series-parallel no series here i just would not. in series parallel i would only run 1/2 power to the subs two of them to get full out put from subs. this or get three one ohm stable amps which i know a couple cheap ones this and you could wire two in parallel and use 3 amps depending on wattage for those in parallel
keep_hope_alivekeep_hope_alive
Snooch to the Nooch
SD I chew on Mike Tyson's ear
Registered: 24/04/07
Posts: 8816
Loc: Quad Cities, IL
Offline
get dual 4 ohm coils. wire each sub in series for six 8 ohm subs. parallel all of them for a 1.33 ohm mono load.
realize that whatever power the amp puts out a 1 ohm will be divided evenly to each sub.
so a 2000W amp would give 333W to each.
_________________________ Don't believe everything you read on an internet forum. Look into the mouth of a person and you'll find lies, wriggling there like maggots, waiting to grow wings. The world has gone mad.
keep_hope_alivekeep_hope_alive
Snooch to the Nooch
SD I chew on Mike Tyson's ear
Registered: 24/04/07
Posts: 8816
Loc: Quad Cities, IL
Offline
that would be 333W to each sub, or 150W to each coil. not much power for sure.
if it's a two channel amp he can split it up so 3 are on each channel for 2.66 ohm stereo.
_________________________ Don't believe everything you read on an internet forum. Look into the mouth of a person and you'll find lies, wriggling there like maggots, waiting to grow wings. The world has gone mad.